06_ preparing the installation
preparing the installation
SHAPE OF THE OUTDOOR UNIT
Shape
Heat Pump RD075/100VRX RD125VRX
ACCESSORIES
• Keep supplied accessories until the installation is finished.
• Hand the installation manual over to the customer after finishing installation.
• The quantities are indicated in parentheses.
Optional accessories
• The following accessories are needed when installing the outdoor and indoor unit.
Installation manual (1) Drain plug (2) Cable tie (4)
Cap drain (2)
Remarks
- - -
For closing the drain hole
Type Model Capacity of outdoor unit
Y-joint
MXJ-YA1509 51MBH and below
MXJ-YA2512 51~138MBH
MXJ-YA2812 138~160MBH
MXJ-YA2815 160~240MBH
MXJ-YA3119 240~336MBH
MXJ-YA3819 336~438MBH
Y-joint
(Only for DVM PLUS III HR module)
MXJ-YA1500 80MBH and below
MXJ-YA2500 80~240MBH
MXJ-YA3100 240~468MBH
Header joint
MXJ-HA2512 160MBH and below
MXJ-HA3115 160~240MBH
MXJ-HA3819 Over 240MBH
Outdoor joint MXJ-T3819 12~30Ton
Outdoor joint
(Only for DVM PLUS III HR module)
MXJ-T3100 12~30Ton
• When the indoor units without EEV such as wall mounted and ceiling type are installed, it is
necessary to install distribution kits.
• It is necessary to install MCU when HR units are installed.
• Distribution kits and MCU should be purchased from the factory.
DVM PLUS3 HR_IM_E_32805-2.indd 6 2011-11-11 오후 4:18:09
To Next Page
Loading...
