Installer reference guide / Mono tank integrated type 6
1.1 General
• All materials supplied in this manual are indispensable for the safety of the equipment.
Users shall establish appropriate safety and health practices and determine the applicability of regulatory limitations
based on the
following descriptions before use.
• Always disconnect the air to water heat pump from the power supply before servicing it or accessing its internal
components.
• Verify that installation and testing operations are performed by qualified personnel.
• Verify that the air to water heat pump is not installed in an easily accessible area (vandalism/ sabotage/ other harmful
activities).
• Carefully read the content of this manual before installing the air to water heat pump and store the manual in a safe
place in order to be able to use it as a reference after the installation.
• For maximum safety, installers shall always carefully read the following warnings.
• Store the user and installation manual in a safe location and remember to hand it over to the new owner if the air to
water heat pump is sold or transferred of ownership.
• This manual explains how to install an indoor unit and an outdoor unit.
Use of other types of devices with the control system may damage the device and void the warranty.
The manufacturer shall not be responsible for damages arising from noncompliant units or parts.
•
The manufacturer shall not be responsible for damage originating from unauthorized changes or the improper
connection of electric and hydraulic lines. Failure to comply with these instructions or to comply with the
requirements outlined in the “Operating limits” table included in the manual shall immediately invalidate
the warranty.
•
To prevent serious system damage and user injuries, precautions and other notices shall be observed.
• Failure to comply with these instructions or to comply with the requirement on the operating range outlined in the
Product specification shall immediately invalidate the warranty.
Model Heat Cool
Mono HT Quiet
AE080BXYD**
AE120BXYD**
AE140BXYD**
-30~43°C 10~46 °C
Mono
AE050RXYDEG
AE080RXYD**
AE120RXYD**
AE160RXYD**
-25~35°C 10~46 °C
• Do not use the units if you see some damages on the units and recognize something problematic such as loud noise or
smell of burning.
• To prevent electric shocks, fires or injuries, always stop the unit, ultimately rendering the product powerless. Contact
Samsung’s technical support if the unit produces smoke, if the power cable is hot or damaged or if the unit is very noisy.
• Always remember to inspect the unit, electric connections, refrigerant pipework and protections regularly.
These operations shall be performed by qualified personnel only.
•
The unit contains moving and electrical parts, which should always be kept out of the reach of children.
To Next Page
Loading...
