E-12
If necessary, press (ON/OFF) button.
Result: : ◆ The On/Off indicator on the function
controller comes on.
◆ The air conditioner runs in the mode
selected when the unit was last used.
1
If the atmosphere in your room is very humid or damp,
you can remove excess humidity without lowering the
room temperature too much.
To select the DRY mode, press the Mode button until
is displayed at the top of the function controller.
Result:
: ◆ The air conditioner runs in DRY mode.
2
The air conditioner is fitted with a
protection mechanism to prevent the unit
from being damaged when it is started
immediately after being:
◆ Plugged in
◆ Stopped
It will start up normally after three minutes.
IMPORTANT
◆ You can change modes at any time.
N
N
o
o
t
t
e
e
Removing Excess Humidity
To Next Page
Loading...
