4. Enter your current zip code and tap
Done
. This zip code
must correspond to the location of your desired TV and
set top box.
5. From the
Find your TV service
screen, select a service
provider from the available channel listing.
6. From the
Personalize
screen, you can either follow the
on-screen prompts to personalize your desired content
or tap
Skip
to continue without customizing your
content.
7. Read the on-screen Peel Disclaimer agreement and tap
Agree
to complete the set up process.
Customizing Your Remote
1. From the top of the main screen, tap (
Remote
Control
)
Set Up Now
.
2. From the
Select your TV brand
screen, tap your TV’s
manufacturer name.
•
If you have a brand of TV not listed or you are using a projector,
select from one of the following two options. Choose from
either
Show other brands
or
I have a home projector
.
3. Aim your device at the TV and tap (
Power
) to
confirm the set up process completed successfully and
the correct TV IR codes were selected.
Note:
The process of the initial TV activation can take up to 10
seconds. Please do not press the button again.
4. If the TV turned on, tap
Yes, this code 1 works
.
– or –
If the TV did not turn on after tapping
(
Power
) and
waiting 10 seconds, tap
No, test next code 2
or
Send this code 1 again
.
5. From the
Select your channel source
screen, select the
entry that corresponds to your current channel control
method:
•Set-top Box
: selected when changing channels is done via a
receiver box. Channels are not changed via the TV remote but
rather through the receiver/box.
• My xxx TV
: selected when a signal is fed directly into the TV
and no box is used. Channels are changed directly on the TV by
using the TV remote and not a box’s remote.
Applications 202
To Next Page
Loading...
