19
GB
18
OPERATION
Press SETUP button.
•
“SETUP MODE” appears on the display and goes into Setup Mode.
Press FUNCTION button to select the “SPK SETUP”.
Press SURROUND MODE button to select the speaker
you want.
•
Each time you press this button, F.SPK ➝ C.SPK ➝ S.SPK ➝ SWSPK ➝
CROVR will be selected in turn.
Press SELECT ( ) button to set the mode
for the selected speaker.
Repeat steps 3-4 to adjust each speaker.
To exit setup mode
•
Wait for about 5 seconds or press SETUP button.
“SETUP OFF” appears on the display and Setup Mode is exited.
•
LARGE : Select when using large speakers. You can listen to full
range sound.
•
SMALL : Select this when using small speakers
•
NONE : Select when you use no speaker.
•
YES (subwoofer) : Select when using the subwoofer speaker.
•
NO (subwoofer) : Select when not using the subwoofer speaker.
•
CROVR : Select the crossover frequency for the best bass
response in your room.
MAIN UNIT
1
2
4
5
3
Setting the Speaker Mode
Signal outputs and frequency response from the speaker will be adjusted according to your speaker configuration
and whether certain speakers are used or not.
Press MENU button, and then press ENTER button.
•
“SETUP MODE” appears on the display and goes into Setup Mode.
Press button to select the “SPK SETUP”, and then
press ENTER button.
Press button to select the speaker you want.
•
Each time you press this button, F.SPK ➝ C.SPK ➝ S.SPK ➝ SWSPK ➝
CROVR will be selected in turn.
Press …† button to set the mode (Large, Small etc.)
for the selected speaker.
Repeat steps 3-4 to set the mode for each speaker.
To turn the SUBWOOFER on or off.
Press SUBWOOFER ON/OFF button on the remote.
•
Each time you press this button, SWSPK : YES, SWSPK : NO will be selected
in turn.
√
•
If FRONT is set to LARGE, you can select YES or NO for SWSPK.
•
If FRONT is set to SMALL, SWSPK is automatically set to YES.
NO cannot be selected.
1
2
1 Press SPK SELECT button to select the speaker you want.
•
Each time you press this button, F.SPK ➝ C.SPK ➝ S.SPK ➝ SWSPK ➝
CROVR ➝ SPK MODE OFF will be selected in turn.
2 Press …† button to set the mode (Large, Small etc.)
for the selected speaker.
3 Repeat steps 1-2 to set the mode for each speaker.
3
4
5
REMOTE CONTROL
To set the cross over.
Press CROSS OVER button, and then press …† button
to set the cross over frepuency.
To exit setup mode
•
Wait for about 5 seconds or press MENU button.
“SETUP OFF” appears on the display and Setup Mode is exited.
Setting the Speaker
SPEAKER
F.SPK(Front)
C.SPK(Centre)
S.SPK(Surround)
SWSPK(Subwoofer)
CROVR
(Crossover Frequency)
Possible Settings
LARGE,SMALL
LARGE,SMALL,NONE
LARGE,SMALL,NONE
YES
,NO
60,80,100,120,
150,180,200(Hz)
Default Setting
SMALL
SMALL
SMALL
YES
150Hz
Using the SPK SELECT button
To Next Page
Loading...
