27
GB
26
OPERATION
Test Tone
Use test tone to check the speaker connection status or level.
√
To automatically output test tone
REMOTE CONTROL
Press SETUP button.
•
“SETUP MODE” appears on the display and goes into Setup Mode.
Press FUNCTION button to select the “TEST-T AUTO”.
Press SURROUND MODE button.
•
Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝
S.R ➝ S.L ➝ S.W .
•
During test signal output, press SELECT ( ) button to adjust the speaker
output level from -10 to +10 dB by 1 step.
1
2
3
To stop test tone
•
Press SETUP button once time.
“SETUP OFF” appears on the display and test tone stops.
MAIN UNIT
Press MENU button, and then press ENTER button.
•
“SETUP MODE” appears on the display and goes into Setup Mode.
Press button to select the “TEST-T AUTO”,
and then press ENTER button.
•
Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝
S.R ➝ S.L ➝ S.W .
•
During test signal output, press …† button to adjust the speaker output level
from -10 to +10 dB by 1 step.
1
2
To stop test tone
•
Press MENU button once time.
“SETUP OFF” appears on the display and test tone stops.
Press TEST TONE button.
•
Test signal will be automatically output as follows; F.L ➝ CEN ➝ F.R ➝ S.R ➝
S.L ➝ S.W.
•
During test tone output, press …† button to adjust the speaker output level from
-10 to +10 dB by 1 step.
Using the Test Tone button
To Next Page
Loading...
