Samsung HT-AS1 - Page 15

29
GB
28
OPERATION
Test Tone
(Con’t)
Use test tone to check the speaker connection status or level.
√
To Manually Output Test Tone
• F.L (front left) : -10 ~ +10dB
• CEN (centre) : -10 ~ +10dB
• F.R (front right) : -10 ~ +10dB
• S.R (surround right) : -10 ~ +10dB
• S.L (surround left) : -10 ~ +10dB
• S.W (subwoofer) : -10 ~ +10dB
Test Tone Output
Press SETUP button.
• “SETUP MODE” appears on the display and the unit goes into Setup Mode.
Press FUNCTION button to select the “TEST-T MANU”.
Press SURROUND MODE button.
• Each time you press this button, F.L ➝ CEN ➝ F.R ➝ S.R ➝ S.L ➝ S.W
will be selected in turn.
Press SELECT( ) button to set the test tone as you
want.
• You can adjust the speaker output level from -10 to +10dB by 1 step.
• The sound gets quieter at -10dB and louder at +10dB.
MAIN UNIT
1
2
4
3
To stop test tone
• Press SETUP button once time.
“SETUP OFF” appears on the display and test signal stops.
,
REMOTE CONTROL
Press MENU button, and then press ENTER button.
• “SETUP MODE” appears on the display and goes into Setup Mode.
Press button to select the “TEST-T MANU”,
and then press ENTER button.
Press button to select the speaker you want.
• Each time you press button, F.L ➝ CEN ➝ F.R ➝ S.R ➝
S.L ➝ S.W will be selected in turn.
Press …† button to set the test tone as you want.
• You can adjust the speaker output level from -10 to +10dB by 1 step.
• The sound gets quieter at -10dB and louder at +10dB.
1
2
3
4
To stop test tone
• Press MENU button once time.
“SETUP OFF” appears on the display and test tone stops.