Payback
DISC PLAYBACK
t. Press the OPEN/CLOSE (_) button to open the disc tray.
2. Loada disc.
,, Place a disc gently into the tray with the disc's label
facing up.
S. Press the DISC SKIP button.
,, Rotate the carousel tray so you can load the third,
fourth, and fifth discs.
4. Close the compartment by pressing the OPEN/CLOSE ('J_)
button again.
,, Playback starts automatically.
To stop playback, press the STOP (®) button during playback.
• If pressed once, PRESS PLAY isdisplayed and the stop position will be stored in memory.
If the PLAY (®) button or ENTER button is pressed, playback resumes from the stop position.
(Thisfunction works only with DVDs.)
• If pressed twice, STOP isdisplayed, and if the PLAY (®) button is pressed, playback starts from the
beginning.
To temporarily pause playback, press the PAUSE((.}) button during playback.
• To resumeplayback,pressthe PLAY(Q) button.
_ Depending on the content of tile disc, tile initialscreen may appear different.
Pirated discs will not run in tills player because it violates the CSS (Content Scrambling System :
a copy protection system) recommendations.
Selecting a Disc in the Disc changer
To select a specific disc, press the corresponding the DIRECT
PLAY (1,2, 3, 4, 5) buttons on the front panel or the DISC SKIP
button on the remote control, until the required disc indicator
flashes.
,, If the disc selected is not loaded, the next disc is played
automatically.
35
To Next Page
Loading...
