Samsung HT-Z510 - ASC Calibration Process; ASC Setup Procedure; Canceling ASC Setup; Listening in ASC Mode

ASC (Auto Sound Calibration) SETUP
1. Plug the ASC microphone into the ASC input jack.
2. Place the ASC microphone at the listening position.
3. PressASC button.
,, To create the optimal 5.1 channel sound field,the
selections are in the following sequence:
L-, C-_ R -, SR -, SL-* SW
4. When the message "REMOVEMIC" appears in the display,
unplug the ASC microphone.
[_ '_ Setting the ASC function takes about 3 minutes.
To cancel the ASC (Auto Sound Calibration) setup, press ASC
button.
The tone output stops, "CANCEL ASC" appears in the display followed by "REMOVE MIC", and the
setup is cancelled.
To listen in the ASC (Auto Sound Calibration) mode, briefly press
ASC button.
The selection alternates between ASC ON and ASC OFF inthe display.
Ifyou select "ASC ON", you will hearsound in the ASC mode.
Ifyou select "ASC OFF", you will hear sound in the mode set in the audio setting of the setup screen.
64