16
English
Installation/Service mode
Additional functions of the Wired Remote Controller
1 If you want to use the various additional functions for your Wired Remote Controller, press the and buttons at
the same time for more than 3 seconds.
࡙ The password entry screen appears.
2 Enter the password, 0202, and then press the button.
࡙ The settings screen for installation/service mode appears.
3 See the list of additional functions for the Wired Remote Controller on the next page, and then
select the desired menu.
࡙ Once you have entered the setting screen, the current setting appears.
࡙ Refer to the chart for data setting.
࡙ Using the
/ buttons, change the settings and press the button to move to the next setting.
࡙ Press the
button to save the new setting.
࡙ Press the
button to move to the Home screen.
NOTE
࡙ While setting the data, you can press the button to move to the Home screen after checking the
saving status at a pop-up screen.
Installation/Service mode
To Next Page
Loading...
