Installation/Service mode
22
Installation/Service mode
Step 1 Step 2 Step 3 Description Default
Self-test mode Self-test mode display
On
/
Off Off
Self-test mode display
Water pump
On
/
Off Off
Booster heater
On
/
Off
Off
DHW valve (3way
valve)
On
/
Off
Off
2way valve 1
Off
Backup heater1
Off
Backup heater2
Off
Backup boiler
Off
2way valve 2
Off
Mixing valve
Off
Indoor unit options
Product
Indoor unit product info
Installation 1
Indoor unit Installation
1 info
Installation 2
Indoor unit Installation
2 info
Indoor Address
Indoor unit indoor
address
Field setting value
Simple setting Enter FSV ID and value
FSV upload
Read indoor unit FSV
settings
FSV download (to
Indoor)
Write indoor unit FSV
settings
ODU K3 reset K3 reset
Reset all service mode
data
Reset service settings
Service mode history
View history of service
settings
•
Note1)
Changing the Heating type in Zone 1 or Zone 2 changes the image shown in Overview. After making a
Heating type change, the product must be rebooted and re-registered in SmartThings.
•
Note 2)
Temperature calibration is activated only when Controller installed indoors > Use controller
temperature data is selected.
•
Note 3)
After making a change to Activating hot water function (3011) settings, the product must be rebooted
and re-registered in SmartThings.
•
Note 4)
PV control must be set to Used to access the PV energy saving menu.
•
(*1)
The value is determined according to the type of hydro unit.
•
(*2)
The value is determined according to the type of outdoor unit.
DB68-12922A-02_IB_24Y EHS AE7000D_EU_EN_.indd 22DB68-12922A-02_IB_24Y EHS AE7000D_EU_EN_.indd 22 2024-12-11 오전 10:04:402024-12-11 오전 10:04:40
To Next Page
Loading...
