Samsung NH080PHXEA - Space Cooling Operation

Operating basic function _19
SPACE COOLING OPERATION
In this mode, cooling will be activated as required by the water temperature set point.
• The set point can be set manually
• or set weather dependant
1.
Press
Power(Space mode)
button to turn on the heat
pump unit.
The heat pump will be turned on in the mode you select.
• Space water cooling devices: Radiator or Fan coil unit
(field supply)
• Heating and cooling mode can not be selected at
the same time.
• Space cooling operation is not possible if the
installation is a heating only installation.
The heat pump has a built-in protection mechanism
to prevent the unit from being damaged when it is
started immediately after being plugged in or stopped,
the heat pump will start up after 3 minutes.
2.
Press the
Mode(Space mode)
button twice to select the space cooling mode.
The heat pump will run on cooling mode.
3.
Press
Up

or
Down

button to set the desired temperature.
The temperature can be set between 5ºC to 25ºC.
The temperature is adjusted by 0.5ºC.
CAUTION