Samsung NX1 - Adjusting the Flash Intensity

118
Shooting Functions > Flash
Adjusting the ash intensity
When the ash is on, adjust the ash intensity +/-2 levels.
To set the ash
intensity,
In Shooting mode, select [m] ĺ b ĺ Flash ĺ an option
ĺ [D] ĺ scroll command dial 1 or command dial 2 or
rotate the navigation button or press [e/e] to adjust the ash
intensity.
Menu
Back Set Reset
Flash : Fill in
• You can also drag the slider or touch / to adjust the intensity.
• Adjusting the flash intensity may not be eective when:
- The subject is too close to the camera.
- You set a high ISO sensitivity.
- The exposure value is too big or too small.
- It is too bright or too dark.
• In some shooting modes, you cannot use this function.
• If you attach an intensity-adjustable external ash to the camera, the intensity
settings of the ash will be applied.
• If the subject is too close when you use the ash, some light may be blocked,
resulting in a dark photo. Ensure that the subject is within the recommended
range, which varies by lens.
• When a lens hood is attached, the light from the ash can be blocked by the
hood. Remove the hood to use the ash.