Samsung NX1 - Setting Wireless Sync for Internal or External Flash

120
Shooting Functions > Flash
Setting wireless sync for internal or external ash
Set wireless sync to control internal and external ash units remotely
via wireless signals. The remote system consists of a master ash that is
mounted on the camera and one or more slave ash units. A slave ash is
assigned to one of three groups: A, B, or C.
To set wireless
sync,
In Shooting mode, press [m] ĺ b ĺ Internal Wireless
Flash or External Wireless Flash
ĺ an option.
* Default
Option Description
Use Wireless
Flash
Set to use wireless sync. (O*, On)
Channel
Select channels for wireless sync. There are four remote
channels available to allow multiple remote systems to
operate at the same time. Master and slave ash units, in
the same remote system, must be set to the same channel.
(Ch. 1, Ch. 2, Ch. 3, Ch. 4)
Group Flash
Mode
Set the ash mode for group A, B, or C. Changes to the
ash mode must be made on the master ash. The
changes are then applied to slave group A, B, or C, and
the slave groups operate as a remote system of the ash
mode (TTL or manual) according to the settings for the
master ash.
• A-TTL: Set the exposure of the ash when the ash
mode is A-TTL.
• Manual Flash: Set the brightness of the ash when the
ash mode is Manual Flash.
• O: Do not re the ash.
• You cannot select External Flash Settings when you use the External
Wireless Flash function.
• For information about using the wireless sync feature with an external ash,
refer to the optional external ash’s (SEF-580A) user manual.