Samsung NX300 - Page 21

Copyright ⓒ since 1995 Samsung Electronics. All rights reserved. 3-7
Disassembly and Reassembly
Fig. 3-13
Fig. 3-12
14. Remove the FPCB from the connector as illustrated in Fig. B, Fig. C and Fig. D
15. Remove the 3 screws.
CAUTION
!
1. Open. 2. Remove.
FPCB
FPCB
Fig. B
1. Open. 2. Remove.
FPCB
FPCB
SCREW TAP
6003-001739
④ Remove the FPCB.
FPCB
FPCB
Fig. D
Fig. C
2. Remove.
1. It is installed.
③
④
②
①
13. Remove the following parts in the order indicated below.
① SHAFT BATTERY COVER (Refer to Fig. 4.)
② ASSY COVER BATTERY
③ BATTERY COVER SPRING
SHAFT BATTERY COVER을
핀셋으로 잡아 올려 분리 합니다.
Lift up the SHAFT BATTERY COVER
with tweezers and remove it.
Fig. 4
SHAFT BATTERY COVER ①
ASSY COVER BATTERY ②
③ BATTERY
COVER SPRING
①, ② Remove the FPCB from the connector.
③ Remove the FPCB from the connector .
Use extra care when removing the FPCB from the connector.