8-10
Copyright
ⓒ
since 1995 Samsung Electronics. All rights reserved.
<How to adjust>
1. Copy the below script le to SD card.
2. Install the mount cap to block the light.
3. When turning on the camera, the process will proceed automatically.
- Camera temperature should be more than 35 degree to proceed the VFPN adjustment.
- Camera may heat up during the operation due to the camera being on for extended periods of time.
(Tip. If you use hairdryer, you can heat it up faster.)
Fig. 8-18
8-7 VFPN & CMOS Defact Adjustment
■ This section describes how to correct the vertical noise & defect pixel according to CIS Temperature.
Mount Cap
Required equipment
Mount cap
info.tg
nx300_vfpn.adj
<Attach the mount cap>
To Next Page
Loading...
