iii
Chapter 11 Adding Interface Cards to the System ...................................... 11-1
Adding Interface Cards .......................................................................................................................... 11-1
Grading the OfficeServ500 For DTMF Receivers ............................................................................... 11-1
Chapter 12 SVMi-8 /16 and Cadence Voice Mail Setup .............................. 12-1
Introduction ........................................................................................................................................... 12-1
LED Indications ............................................................................................................................ 12-1
Reset Button ................................................................................................................................. 12-1
Power Requirements .................................................................................................................... 12-1
Configuring the VM System ................................................................................................................. 12-2
Testing the Hardware ............................................................................................................................ 12-2
Chapter 13 Upgrading an iDCS500 to an OfficeServ500 System ............... 13-1
Appendix A Processor and Interface Card LED Indications........................... A-1
List of Figures
1-1 OfficeServ500 Cabinet Dimensions
2-1 System Wall Mounting
2-2 Attaching Legs to Main Cabinet
2-3 Side Cover Mounting Brackets
2-4 Securing Cabinet in Rack
3-1 System Grounding
3-2 Power Input Location
3-3 Setting Voltage on PSU
3-4 Reserve Power Battery Connections
4-1 MCP2 Card
4-2 MCP2 Card Location
4-3 SCP2 Card
4-4 LCP2 Card
4-5 ESM Board
4-6 MCP2 / LCP2 Card Screw Locations
4-7 MISC Board
4-8 SCP2 Card Screw Locations
4-9 SCM Board
4-10 MFM Board
4-11 RCM Board
4-12 Modem Board
4-13 IOM Board
4-14 IOM Board Slot in KSU
4-15 Interface Cards
4-16 TEPRI Card
4-17 TEPRI Card Screw Locations
4-18 MDF Connections RJ-45 to 8BSI Card
4-19 AA Card
To Next Page
Loading...
