Samsung POWERbot SR20H9050U Series User Manual (English)

Questions and Answers:

E
Eric ReillySep 7, 2025
Why is point cleaning not working on my Samsung POWERbot SR20H9050U POWERbot?
- N
  Natasha BowersSep 7, 2025
  If point cleaning is not working on your Samsung Vacuum Cleaner POWERbot, avoid pointing the red light directly at the POWERbot; instead, point it at the floor within 50 cm. Also, do not use point cleaning under direct sunlight, bright light, or on dark floors.
D
Denise FigueroaSep 9, 2025
Why is the Samsung POWERbot SR20H9050U suction weak?
- T
  thomaswoodsSep 9, 2025
  The suction power of your Samsung Vacuum Cleaner might be weak due to several reasons: a full dustbin, a blocked intake, or a dirty filter. To resolve this, turn off the emergency switch and empty the dustbin. Also, remove any foreign matter from the intake. If the filter inspection indicator is on, clean the dustbin. If a noise suddenly increases, turn off the emergency switch and empty the dustbin.
D
David WalkerSep 12, 2025
What to do if my Samsung Vacuum Cleaner stops during cleaning?
- J
  Jeffery RoySep 12, 2025
  Your Samsung Vacuum Cleaner might stop during cleaning due to a depleted battery or obstacles. If "Lo" is displayed, carry the POWERbot to the charger. If it's stuck on a cord or threshold, pick it up and remove the obstacle. Also, turn off the emergency switch and remove any fabrics or strings caught in the drive wheel before using it again.
C
Carlos BowmanSep 13, 2025
Why does my Samsung Vacuum Cleaner go past the Virtual guard?
- X
  xbullockSep 13, 2025
  If your Samsung Vacuum Cleaner passes through the Virtual guard, the batteries in the virtual guard might be depleted. Replace them with 2 type D (LR20) batteries. Also, check if the Virtual guard is turned off, and if so, turn it on.