75
Auto Source Switching
MENU m → System → Auto Source Switching → ENTER E
Turning on the display with Auto Source Switching On, and the previous video source selection is not
active, the display will automatically search the different video input sources for active video.
Auto Source Switching
When the Auto Source Switching is On, the display video source will automatically be searched for
active video.
The Primary Source selection will be activated, if the current video source is not recognized.
Secondary Source selection will become active, if no primary video source is available.
If both the primary and secondary input sources are not recognized, the display will perform two searches
for an active source, each search checking the primary and then secondary source. If both searches fail,
the display will return to the first video source and display a message indicating that there is no signal.
When the Primary Source selection is set to All, the display will search all the video source inputs twice
in sequence looking for an active video source, returning back to the first video source in the sequence if
no video is found.
Primary Source Recovery
Select whether to restore the selected primary input source when a primary input source is connected.
―
The Primary Source Recovery function is disabled if Primary Source is set to All.
Primary Source
Specify Primary Source for the automatic input source.
Secondary Source
Specify Secondary Source for the automatic input source.
―
The Primary Source Recovery function is disabled if Primary Source is set to All.
Power Control
MENU m → System → Power Control → ENTER E
Auto Power On
This feature automatically turns on the product as soon as it is plugged in. Pressing the power button is
not needed.
•
Off / On
Max. Power Saving
Turns off the product to reduce power consumption after the PC has been left idle for a specified period
of time.
•
Off / On
―
Available only HDMI mode.
Standby Control
You can set the screen standby mode to be applied when an input signal is received.
•
Auto
Power-saving mode will activate if no input signals are detected even though a source device is
connected to the display.
The message No Cable Connected will appear if no source device is connected.
•
Off
The message No Cable Connected will appear if no input signals are detected.
―
The Standby Control option is only enabled when Source is set to HDMI1, HDMI2.
―
If No Cable Connected is displayed although a source device is connected, check the cable
connection.
―
If No Signal Message is set to Off, the No Cable Connected message does not appear.
If this is the case, set No Signal Message to On.
•
On
Power-saving mode will activate if no input signals are detected.
To Next Page
Loading...
