65
ENGLISH
Playing back a Tape
Connecting to a TV which has no Audio and Video input jacks
✤
You can connect your camcorder to a TV through a VCR.
1. Connect the comcorder and VCR with the Audio/Video cable.
■
The yellow plug : Video
■
The white plug : Audio(L)
■
The red plug : Audio(R) – STEREO only
2. Connect a TV with the VCR.
3. Set the power switch of camcorder to PLAYER.
4. Turn on the TV and VCR.
■
Set the input selector on the VCR to LINE.
■
Turn on the TV and select the channel reserved for your VCR on the TV.
5. Playback a tape.
✤
You can play the recorded tape in PLAYER mode.
1. Connect a power source and set power switch to PLAYER.
■
Set the mode switch to CAMCORDER. (SCD75/D77 only)
2. Insert a tape you want to see.
3. Using (FF) and (REW) buttons, find the part of the tape you want to see.
4. Press the (PLAY/STILL) button.
■
The picture you recorded appears on the TV after a few seconds.
■
If the tape reaches its end during playback, the tape will rewind automatically.
Notes
■
It is best to decrease the volume of the built-in speaker when your camcorder is connected to the TV.
■
The playback mode (SP/LP) is selected automatically.
Playback
To Next Page
Loading...
