4.1.6.3 General Settings
Before you get ready to using the machine, it is recommended to set up the machine parameters.
1. Press Machine Setup on the control panel.
2. Press Admin Setting. When the login message pops up, then enter password and press OK. (Factory
setting is 1111.)
3. Press the General tab.
Option Description
Device Info The sub-options available are Service Center Registration and Contact Info.
You may enter information on service center and purchasing point.
Date & Time You can set the date and time.
Default Settings
• Default Window: Set the rst window that will appear on the display screen
after turning on the machine or waking up from the Low Power Mode to
Sleep Mode. For example, if you select Fax as a default window, the rst
window will be the Basic tab of the Fax feature. In case you want to show ID
Copy as a default window, you need to enable this feature in Default Option
previously.
• Default Option: Changes all the default values for copying, faxing, emailing,
scanning and paper at once.
Measurements This option lets you change the measurement unit to use (mm or inch), and set
the numeric separation (comma or period).
Timers The machine cancels a printing job if data does not be received in specic
time.
• System Timeout: The machine returns to the default value after certain time
the machine waits. You can set a time for maximum 10 minutes.
• Held Job Timeout: The machine holds a job for a specic time period. You
can set a time period for at least an hour.
Language It allows you to change the language that appears on the touch screen.
Energy Saver You can reduce energy consumption by setting these features. Energy Saver
has three options, rst Low Power Mode to Sleep Mode turns off the scanner
lamp under the glass. And Power Save turns off all the fans within the machine
after a certain time. Standby to Low Power Mode turns off the fans within the
machine except a core fan for the fuser unit.
To Next Page
Loading...
