Samsung SDC-415 Series - Page 10

COLOR CCD CAMERA User’s Manual
19
COLOR CCD CAMERA User’s Manual
18
※ Pleaseselectoneofthe3modesbelow.
➲

ATW(Auto Tracking White Balance) : This mode can be used within the color
temperature range 1,800°K ~ 10,500°K (Ex. fluorescent light, outdoor, sodium vapor
lamp or inside tunnels)

➲

AWC(Auto White Balance Control) : Please press the SETUP button while the
camera is directed at a piece of white paper to obtain the optimum state under current
illumination. If the environment including the light source is changed, you have to
adjust the white balance again.

➲

MANUAL : The manual adjustment mode enables finer adjustment.
Please select ATW or AWC first. Please change to manual adjustment mode and press
the SETUP button. Please set the appropriate color temperature, and then increase or
decrease the red and blue color values while monitoring the color changes on the object.
• UnderthefollowingconditionstheWHITEBALANCEfunctionmaynotoperateproperly.In
suchcases,pleaseselecttheAWCmode.
❶
Whentheobject´ssurroundingshaveaveryhighcolortemperature(Ex.aclearskyandsunset)
❷
Whentheobject´ssurroundingsaredark
❸
If the camera directly faces a fluorescent light or is installed in a place where there are
considerablechangesinillumination,theWHITEBALANCEfunctionmaybecomeunstable.
Notes
Camera Operation
BACKLIGHT (Backlight Compensation)
AGC (Auto Gain Control)
Whenthereisastrongbacklightbehindtheobject,clearimagesofthebackgroundas
wellastheobjectcanstillbeobtainedbyusingtheBACKLIGHTfunction.
1. Please position the arrow to point to 'BACKLIGHT' on the SETUP menu by using the UP
and DOWN buttons.
2. Please select the mode you wish to operate by pressing the LEFT or RIGHT button.
➲ HIGH/MIDDLE/LOW :
You can adjust the sensitivity of BLC and
BLC window´s size and position. So that, It can
achieve BLC function efficiently regardless of
position of subject.
➲ OFF : BLC function doesn´t operate.
BACKLIGHTON
BACKLIGHTOFF
The higher gain level, the screen gets brighter and the level of noise also increases.
TheBRIGHTNESScanbeadjustedwithintherangeof1~70
1. Please position the arrow to point to 'AGC' on the SETUP menu by using the UP and
DOWN buttons.
2. Select a desired mode using the Up and Down buttons.
➲ HIGH : The gain increases or decreases within the range of 6dB ~ 34dB.
➲ MIDDLE : Thegainincreasesordecreaseswithintherangeof6dB~30dB.