Samsung SDC-415 Series - Camera Operation; Settings

COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual
1514
• As shown in the table above, voltage decreases as the wire gets longer.
Therefore use of an excessively long adaptor output line for connection to the camera may
affect the performance of the camera.
※ Standard voltage for camera operation : DC 12V±10%
※ There may be some deviation in voltage drop depending on the type of wire and the manufacturer.
Whentheresistancevalueofcopperwireisat[20°C(68°F)]
Installation
Camera Operation
Copperwiresize(AWG)
#24(0.22mm2) #22(0.33mm2) #20(0.52mm2) #18(0.83mm2)
Resistancevalue(Ω/m)
0.078 0.050 0.030 0.018
Voltagedrop(V/m)
0.028 0.018 0.011 0.006
Menu
SETUP menu
LENS (selection) • MANUAL • DC / VIDEO
SHUTTER
(condition and speed control)
• ESC • MANUAL • FLK
WHITE BALANCE control • ATW • AWC • MANUAL
BACKLIGHT
(Backlight compensation)
• OFF • LOW • MIDDLE
• HIGH
AGC (Auto Gain control)
• OFF • LOW • MIDDLE
• HIGH
SSNR
(Samsung super noise reduction)
• OFF • LOW • MIDDLE
• HIGH
SENS-UP (Low illuminance) • OFF • AUTO
SPECIAL
• CAMERA ID • COLOR
• SYNC • MOTION DETECTION
• PRIVACY • MIRROR
• SHARPNESS • RESET
• RETURN
EXIT
Settings
Settings can be made using the 5 buttons located on the back of the camera.
UPbutton
SETbutton
LEFTbutton
DOWNbutton
RIGHTbutton
1. Press the SET button
• Main setup menu is displayed on the monitor screen.
2. Select a desired function using the Up and Down buttons.
• Place the cursor over a desired item.
3. Set up a selected item by using the Left and Right buttons.
4. To finish the setting, select 'EXIT' and press the SET button.
•If appears at the mode you wish to operate, it means that there is a sub-menu
whichcanbeselectedbypressingtheSETUPbutton.
• If --- appears at the mode item, it means that there is no mode available to be selected.
Notes
Select any function you
wish to operate by using
theUPandDOWNbuttons.
Modescanbechanged
usingtheLEFTandRIGHT
buttons.