Samsung SDC-415 Series - Connecting to Power; Connecting to a Monitor

COLOR CCD CAMERACOLOR CCD CAMERA User’s ManualUser’s Manual
1312
Installation
Please take off the CCD protection cap and
attach the C-Mount lens to the camera by
screwing it in clockwise.
C-mount adaptor
When using a C-Mount lens
When using a CS-Mount lens
1. Please take off the CCD protection cap
and C-mount adaptor.
2. Please attach the CS-Mount lens to the
camera by screwing it in clockwise.
C-mount adaptor
CCD protection cap
• Pleaseusethespecifiedlensconnectionpartsasshowninthepicturebelow.
The use of the wrong sized parts of the wrong size may cause damage to the
inside of the camera or result in poor fitting.
• Useofalenswhichistooheavyaffectsthebalanceofthecameraandmay
causeamalfunction.Pleaseusealensthatweighslessthan450g.
• PleaseselectAvmodeifpossiblewhenadjustingtheautomaticlightcontrol
(ALC)ofanautolens.UseofPKmodemaycausehunting.
Notes
C-mountlens:10mmorless
CS-mountlens:5mmorless
CS-mount adaptor
Connecting to a monitor
Please connect the video output terminal
located on the back of the camera to the
monitor.
• The connection method varies depending on the type of monitor and accessories. Please
refer to the user's manual for each instrument.
• Please turn off the power when connecting.
• Please select Hi-Z on the 75Ω/Hi-Z switch for the intermediate video TV set and select
75Ω for the Intermediate device as shown in the picture below.
CCD Camera
Intermediate Endmonitor
CCD Camera
Monitor
Connecting to power
Each model has a different power input specification.
Please check the model type and standard power requirement before connecting to power.
Use AC24V, 300mA adaptor
For SDC-415NA/SDC-415PA.
Use AC230V, 50Hz power source
For SDC-415PH.
Use DC12V, 500mA adaptor
For SDC-415ND/SDC-415PD.
AC Power Type (AC 24V, 300mA)
High Voltage Type (AC230V, 50Hz)
DC Power Type (DC 12V, 500mA)