Samsung SDC-415 Series - SHUTTER (condition and speed control); WHITE BALANCE control

COLOR CCD CAMERA User’s Manual
25
COLOR CCD CAMERA User’s Manual
24
• Ifthewrongnamehasbeeninput.....
 IfyoupresstheSETUPbuttonaftermovingthecursortoCLR,alltheletterswillbeerased.Ifyouwant
tocorrectaletter,pleasemovethecursortothearrowatthebottomleftofthescreenandpress'SET'.
 Pleasepositionthecursorabovetheletteryouwishtocorrect,andthenmovethecursor
ontotheletteryouwishtochooseandpresstheSETUPbutton.
Notes
5) When a name has been chosen, please select a position for the name display.
❶ Please move the cursor onto 'POS' and then press
the SETUP button.
❷ The name will appear at the top left hand corner.
❸ Please find the position you wish to display the
name by using the 4 directional buttons, and then
press the SETUP button.
6) Please select 'END' and then press the SETUP button to complete ID input.
FRONT DOOR
➲ COLOR (Electronic DAY & NIGHT)
- AUTO : This camera has a function which electronically changes to the appropriate
mode for daytime or night-time. The COLOR mode is operated for daytime, and
it converts to BW mode for night-time.
- ON : The color mode is selected electronically.
❷ Select an ID from A,B~Y,Z, a,b~y,z, 0,1~8,9 by using the UP, DOWN, LEFT and RIGHT
buttons.
❸ Please lock in the letters by using the SETUP button.
• When the letter is locked in, the cursor moves to the next space.
❹ Please repeat the above to input the ID.
Camera Operation
• IfAGCisOFF,youcan´tselectAUTOmode.
• Whenaninfraredlightisused,theremaybeaproblemwithfocusingandCOLOR(DAY&
NIGHT).
Notes
➲ SYNC : Two SYNCHRONIZATION modes are
available INTERNAL and EXTERNAL LINE-
LOCK. In LINE-LOCK mode, it synchronizes
the video signal between cameras without
a synchronous generator. The line-lock
synchronization is only used in the areas
of 60Hz (NTSC Models) / 50Hz (PAL
Models).
- INT : Internal synchronization
- LL : External line-lock synchronization
• If you choose ‘LL’, you can adjust the desired phase. Press the SET button.
• You can adjust the desired phase from 0 to 359.
• Whenthepowerfrequencyis50Hz,youcannotuseline-lockmode(NTSCModels).
• Whenthepowerfrequencyis60Hz,youcannotusetheline-lockmode(PALModels).
• ‘Sync.’modeisfixedto‘INT’inDC12Vinputpower.
Notes