Outdoor, Battery-Powered Camera
J
` Check whether or not the camera installation position is suitable for good video
reception.
1. As shown in the figure, remove the bracket
bottom using a simple tool.
n
` If you are mounting the camera on the wall,
carefully separate the bracket cover from the
bracket.
2. Place the bracket cover against the wall where the
camera will be mounted and mark the position of
the screw holes.
3. Use a drill on the marked positions, and drill holes
to a depth of 3 cm. Clean the holes after drilling.
J
` It is recommended to use a drill bit (Ø5) that is suitable
for the wall material.
` Be careful not to get injured while drilling.
4. Insert an anchor for the two holes. Fully insert
the anchors by gently tapping the anchor
head with a hammer or rubber mallet.
5. Match the bracket cover to the holes on the wall and
fasten the screws.
6. Press the bracket body to the bottom to
assemble.
7. Adjust the angle of view.
J
` Do not use force to adjust it. Unscrew the lever
and adjust it after checking the location of the
groove. Re-tighten the lever.
Bracket Bottom
Bracket body
To Next Page
Loading...
