Samsung SMARTCAM A1 - Station Camera Mobility; Flexible Placement and Long-Lasting Monitoring; Tripod Mounting Option

12 · English
Camera Registration
Pairing
1. Set the station hub and camera in close range of each other. (about
30cm~100cm)
2. Press and hold the [PAIR] button on the camera for 3 seconds, and press
and hold the [PAIR] button on the station hub for 3 seconds.
3. When pairing is complete, the following indicators will be displayed: Blue ON
(station hub) Green ON (station camera), Green turns on for 5 seconds and
then turns off (outdoor battery camera)
n
` Repeat steps 1 through 3 to pair an additional station hub and camera.
` Before pairing, dock the station camera on the station hub to charge it sufficiently.
Camera Installation
Station camera
Dock it on the station hub or place it on a shelf or a flat
place.
When the camera is docked on the station hub,
the camera battery will start to be charged. Pan
(move left/right) and auto tracking are available.
n
` When you remove the camera from the
station hub, the camera (with the battery
fully charged) can operate for 2 to 3 hours.
OFF ON
PAIR
POWER
NETWORK
Wi-Fi
PAIR
PAIR
3 sec
PAIR
3 sec
POWER
NETWORK
Wi-Fi
PAIR
PAIR
3 sec
PAIR
3 sec