What to do if viewer got disconnected during monitoring Samsung SNB-3000?
If the viewer disconnects during monitoring, try these steps: * First, check all network connections to ensure they are stable. * If the camera uses an xDSL network, poor network conditions might be the cause of the disconnection.
What to do if Samsung Security Camera connected to the network is not detected in the IP installer program?
If the camera isn't detected in the IP installer program, turn off the firewall settings on your PC and then search for the camera again.
What to do if I cannot connect to the Samsung SNB-3000 system using a tab browser of Internet Explorer 7.0?
Instead of using a tab browser, open a new browser window to connect to the system.
Why Samsung Security Camera cannot record into the SD memory card?
If you cannot record into the SD memory card, check the following: * Verify if the memory card is defective. * Check if the write protection tab of the memory card is set to 'LOCK'.
What to do if no JPEG file is transferred via FTP/ SMTP on occurrence of intelligent video analysis event of Samsung Security Camera?
If no JPEG file is transferred via FTP/SMTP when an intelligent video analysis event occurs, verify the following settings in sequence: A. NTP must be properly configured. B. The should be set to . C. Alarm Video Transmission must be enabled. D. Check for scheduling conflict.
What to do if my Samsung SNB-3000 images overlap?
If images overlap, check whether two or more cameras are set to a single multicast address instead of different addresses.
What to do if no signal is found at the Alarm Output port even when an intelligent video analysis event is generated on Samsung SNB-3000?
If no signal is found at the Alarm Output port when an intelligent video analysis event is generated, check the alarm output port settings.
Why Samsung SNB-3000 Security Camera SD memory indicator does not turn on even when the SD memory card is inserted?
If the SD memory indicator does not turn on even when the SD memory card is inserted: * Check if the memory card is defective. * Check if the is checked in - - menu.
Why Samsung Security Camera SD memory card is inserted but the camera does not operate properly?
If the SD memory card is inserted but the camera does not operate properly: * Check if the memory card is inserted in the proper direction. * Note that the operation of a memory card formatted by other devices is not guaranteed with this camera unit. * Format the memory card again in - - menu.
General| Image Sensor | 1/3" Super HAD CCD |
|---|---|
| Effective Pixels | 768(H) x 494(V) |
| Power Supply | 12V DC / 24V AC |
| Signal System | NTSC |
| Synchronization | Internal |
| Lens Mount | CS Mount |
| Video Output | 1.0 Vp-p, 75 ohms, Composite |
| Operating Temperature | -10°C to +50°C (14°F to 122°F) |
| Min. Illumination | 0.05Lux (F1.2, 50IRE), 0.0001Lux (Sens-up x512) |
| Minimum Illumination | 0.05 Lux (F1.2, 50IRE), 0.0001 Lux (Sens-up x512) |
To Next Page
