English _23
● INSTALLATION & CONNECTION
Connecting the installation monitor
Connect the cable to the camera’s rear video output terminal and the installation monitor’s
video input terminal.
The wiring varies depending on your monitor type and peripheral devices; please refer to the user manual
for each device.
Please make sure the monitor and camera are turned off when connecting them.
J
This product is a network camera that transfers video over a network; the video output terminal is
used to set the imaging range of the camera at installation.
Using the terminal for monitoring purposes may cause problems such as degradation in video
quality.
It is not suitable for 24-hour monitoring using professional CRT monitors or TFT/LCD portable
monitors.
Use the network transfer screen for 24-hour monitoring and storage.
AC- FG AC-
AUDIO OUT
AUDIO IN
GND
1.COM
1.NO 1.NCIN1 IN2 GND IN3 IN4
2.COM
2.NO
2.NC
D+ D- TXD+ TXD- GND
Monitor
To Next Page
Loading...
