installation & connection
18_ installation & connection
Outdoor installation
When you install the camera outdoors, it should be waterproofed with waterproof butyl
rubber tape (which can be purchased in stores) so that water does not leak from the gap of
the cable connected in the outdoor area.
1. Connect the PoE cable.
2. Wrap the black cable jacket (Area A) and the
cable connection area with waterproof (butyl
rubber) tape so that more than half of the butyl rubber tape is overlapped.
J
If the cable jacket is not waterproofed properly, then it can directly cause leakage. Make sure to
protect the cable with a dense layer of taping.
Waterproof butyl tape is made of butyl rubber that can be stretched to twice its normal length.
Camera System
AA
To Next Page
Loading...
