12_ installation & connection
CONNECTING WITH OTHER DEVICE
Connecting a connector cable (SNV-L6014RM)
Connect the M12 male connector into the hole of the M12 Female connector of the camera.
M
`
This camera uses Female, D-coded types.
`
PoE (Power over Ethernet) is supported.
`
You are recommended to use a shielded network connector.
J
`
Connect this camera to a shielded network cable (STP).
`
Please, use 4 poles, Male, D-coded type external cables that meet the M12 specification.
`
Check whether the PoE device is properly connected to the ground.
TX+
TX-
RX-
RX+
Making a connection using the M12-RJ45 conversion cable (SNV-L6014RM)
Connect the M12 male connector for the conversion cable to the groove of the M12 Female connector for
your camera.
M
`
M12-RJ45 cable is sold separately.
Powering and networking (SNV-L6013R)
Connect a camera to a PoE equipment.
J
`
Connect to a PoE (Power over Ethernet) enabled router’s PoE connector.
`
Use PoE (Power over Ethernet) that is compliant with the IEEE802.3af protocols.
Powering and networking (SNV-L6014RM)
Connect a camera to a PoE equipment or connect the M12-RJ45 connector for the conversion cable of your
camera to a PoE equipment.
J
`
A connection method may vary depending on the installation environment of a user.
`
Connect to a PoE (Power over Ethernet) enabled router’s PoE connector.
`
Use PoE (Power over Ethernet) that is compliant with the IEEE802.3af protocols.
You can only use a Mode A PoE device that supplies power through data pin pair 1, 2, 3, 6.
`
Even if you use the M12-RJ45 conversion cable, you can only use a mode A type PoE equipment that supplies power to data
pair pins 1, 2, 3, 6.
To Next Page
Loading...
