Samsung SNV-L6013R - Video & Audio Setup

English _31
●● SETUP SCREEN
VIDEO & AUDIO SETUP
Video setup
1. From the Setup menu, select the <Video & Audio ( )>
tab.
2. Click <Video setup>.
3. Select a <Video source> mode.
• Flip mode : Turn upside down the image that is captured
by the camera.
• Mirror mode : Flip horizontal the image that is captured by
the camera.
• Hallway view : Rotates a video that was taken from a
camera by a specified angle.
Possible to rotate 0, 90, and 270 degrees.
`
If the setting is changed, the browser window will be closed. Try to
connect again after a while.
J
`
Video output is not supported for the hallway view by SPD-100/400.
4. Specify the privacy zone.
5. When done, click [Apply (
)].
To set the privacy zone
You can specify a certain area of the camera video to be protected for your privacy.
1. Set it to <On>.
2. Click [Apply (
)].
3. Click and drag the desired region on the video.
4. Enter the name and select the color, and then click [OK].
5. If you want to delete a name in the list, select it and click
[Delete (
)].
Audio setup (SNV-L6013R)
You can configure the input settings of the audio source from the camera.
1. From the Setup menu, select the <Video & Audio (
)>
tab.
2. Click <Audio setup>.
3. Set the audio input value.
• Source : Sets the audio input.
- Line : Connect the cable to the audio device.
- External microphone : 3.5 pi(¢) jack type external MIC.
• Apply power to Ext. Mic. : If the external microphone
connected has no separate power supply, check this
option to set camera to supply power to the connected external microphone. The option is enabled if
<External microphone> is selected.
• Codec : Specify the audio codec.
- G.711 : A audio codec standard, it uses 64 Kbps PCM (Pulse Code Modulation) encoding.
ITU standard audio codec that is adequate for digital voice transfer in PSTN network or through a
PBX.
- G.726 : ITU standard audio codec applying ADPCM (Adaptive Differential Pulse Code Modulation) for
variable bit rates of 40/32/24/16 Kbps to 64 Kbps PCM encoding.
• Bitrate : Set the bit rate to differentiate compression ratio if using G.726 codec.
• Gain : Specify the audio input amplification.
J
`
Sound quality deterioration or howling may occur if the loudness of the sound source or gain value were set excessively.
4. When done, click [Apply (
)].