Switching to Single Mode
When in split mode, select and double-click a desired channel to switch to its Single mode.
Press the number corresponding to a desired channel on the front panel or the remote control to switch to its
Single mode.
Refer to “Remote Control > Using the numeric buttons”. (Page 15)
` Ex : If double-clicking CH 3 or pressing the number “3” on the remote control or the front panel.
SPOT OUT
The Spot Out monitoring is independent of the Live mode, which monitors a specific channel through the Spot Out port.
Selecting a Spot Out mode
If an event occurs such as sensor, motion or alarm from the Spot Out port in connection with a monitor, you
can select a output screen mode.
1. In Live mode, right-click any area on the screen.
The Live menu appears.
2.
Click Spot Out.
The split screen appears according to the Spot Out source.
(Page 57)
` Spot Out 1: It supports auto sequence and single mode by default,
and additionally supports 16-split, 9-split and 4-split modes if
selected <Multi Spot> out.
` Spot Out 2: It supports auto sequence and single mode.
To Next Page
Loading...
