Setting the PTZ
To use Camera’s PTZ functions, ID and protocols of each camera and DVR should be matched.
For other settings, refer to the <Remote Device> settings. (Page 54)
Using the mouse may help make setup easier.
1. Use the up/down buttons (▲▼) in <Device> window to
move to <Camera>, and press [ENTER] button.
2. Select <PTZ>.
A window of PTZ settings appears.
3.
Use direction buttons (▲▼_ +) to move to a desired item,
and select it.
•Port : Select a port control method for the camera that is
connected to a channel.
`
You have two choices : <RS-485> and <Coaxial>.
`
<Coaxial> type is only available for SRD-1680D SD channel.
•ID : Set the ID of the connected camera of each channel.
You can easily setup by using the numeric buttons on the remote control or front panel.
•Protocol : Set the protocol of the connected camera of each channel.
M
` You can check the camera’s ID and protocol if you turn the camera off and on after connecting it to the DVR.
` For the <Coaxial> type, CCVC and PELCO-C protocols are supported.
` <Coaxial> type is only available for SRD-1680D SD channel.
` Coaxial function doesn’t work on HD-SDI Channels.
4. When the PTZ setup is done, press <OK>.
CH Port
ID Protocol
1 RS-485
0
>
None
2 RS-485
1
>
None
3 RS-485
2
>
None
4 RS-485
3
>
None
5 RS-485
4
>
None
6 RS-485
5
>
None
7 RS-485
6
>
None
8 RS-485
7
>
None
Camera
PTZ
Camera
Previous/Next Page
OK Cancel
To Next Page
Loading...
