English _169
● APPENDIX
Problem Action
Frame rate of the actual recording does not match
that of configured to the camera.
y
If multiple profiles were applied to one camera for video transmission, the
actual video stream can be serviced by the camera at a lower frame rate than
specified.
Configure your camera to use one profile for data streaming as possible.
For example, if you set the same profile for recording and network profiles,
the actual recording is made at the specified frame rate.
Still, live video display using split screen mode may apply yet another profile
to camera in accordance with the used screen mode.
Note that allowed limit bitrate for recording / recording settings should be set
to be bigger values than that of camera's feed.
Recording is not performed in accordance with the
settings.
y
If the recording status shows that the input data is exceeded.
Then go to Menu – Recording – Recording Setting, and set the max data
capacity to greater than the input data.
The recording screen will slow down. y
Check if the recording spec for each HDD condition (refer to the recording
setting in menu) is appropriate for the actual recording setting.
y
Only main video frames will play if the data data processing rate exceeds the
play performance (refer to the product specifications in menu).
To Next Page
Loading...
