English _97
● MENU SETUP
NETWORK CONFIGURATION
It provides networked monitoring of Live screen from a remote place, and supports mail forwarding function with
events. You can configure the network environment which enables such functions.
Interface
You can set the network connection route and protocol.
Setting a network connection
Sets the protocol and environment of the network.
[MENU] [ENTER] ▼ <Menu> [ENTER] ▼ <Network> ► <Interface> [ENTER] ▼
<Network> ▲▼◄► [ENTER]
• Network1 (Camera) : Port for camera connections; it receives video from a camera.
• Network2 (Viewer) : Port used to send video to the web viewer.
• Network1 (Camera) / Network2 (Viewer) setup
-
IP Type : Select a network connection type.
-
IP Address, Subnet Mask, Gateway, DNS
<Static> : You can manually enter IP address, subnet mask, gateway and DNS.
<DHCP> : IP address, subnet mask and gateway values will be automatically set.
<PPPoE> : IP address, subnet mask and gateway values will be automatically set.
-
User ID, Password : If you set the connection mode to PPPoE, you need to enter "User ID" and
"Password" to register in PPPoE.
• Transfer bandwidth : Enter the maximum amount of upload data bandwidth.
Check the assigned setting in Connection Mode before entering your value.
` If the sum of the network TX/RX is less than 160Mbps, there is a max transmission rate of 160Mbps.
• Default Gateway : Set the basic gateway by using Network1 / Network2 setup.
M
` You can manually input DNS of <DHCP> and <PPPoE> when it selected to <Manual>.
To Next Page
Loading...
