Multi Control
Assigns an individual ID to the SET.
• ID Setup
Assigns distinctive IDs to the SET.
• ID Input
Use to select the transmitter functions of the individual SET. Only a SET where the ID
corresponds to the transmitter setting becomes activated.
• MDC Connection
Selects a port to receive the MDC inputs from.
• Communicates with the MDC via a RS232C MDC cable.
• Communicates with the MDC via an RJ45 MDC cable.
• Network Setting
• IP Setting : Manual, Auto
• IP Address : Manually enter the IP Address if
IP Setting is set to Manual.
• Subnet Mask : Manually enter the Subnet Mask if IP Setting is set to Manual.
• Gateway : Manually enter the Gateway if IP Setting is set to Manual.
MagicInfo
Available Modes
•
PC / DVI / DisplayPort
•
AV
•
Component
•
HDMI
•
MagicInfo
•
TV
Note
• MagicInfo can only be enabled when a network box is connected.
Adjusting the LCD Display
To Next Page
Loading...
