Anynet+ (HDMI-CEC)
To use the Anynet+ Function, Anynet+ (HDMI-CEC) must be set to On.
Note
When the Anynet+ (HDMI-CEC) function is disabled, all the Anynet+ related operations are
deactivated.
Auto Turn Off
Setting an Anynet+ Device to turn Off automatically when the TV is Turned Off and setting a
TV to turn off automatically when a HDMI-CEC device requestes tv to turn off.
Note
The active source on the TV remote must be set to TV to use the Anynet+ function.
If you set Auto Turn Off to Yes, connected external devices are also turned off when the TV
is turned off. If an external device is still recording, it may or may not turn off.
Device List
1. Press the
TOOLS
button. Press the ENTER
button to select Anynet+ (HDMI-CEC).
2. Press the
or button to select Device List, then press the ENTER button.
- Anynet+ devices connected to the TV are listed.
- If you cannot find a device you want, press the red button to scan for devices.
3.
Press the
or button to select a particular device and press the ENTER button. It is
switched to the selected device.
-
Only when you set Anynet+ (HDMI-CEC) to On in the Application menu, the Device List
menu appears.
Note
Switching
to the selected devices may take up to 2 minutes. You cannot cancel the operation
during the switching operation.
The time required to scan for devices is determined by the number of connected devices.
When the device scan is complete, the number of devices found are not displayed.
Although the TV automatically searches the device list when the TV is turned on via the power
button, devices connected to the TV when the TV may not always be automatically displayed
in the device list. Press the red button to search for the connected device.
Adjusting the LCD Display
To Next Page
Loading...
