Installation
52
Placing the Indoor Unit in Position
4
Installation
plate
Once you have checked that there are no leaks in the system, you can insulate the piping,
hose and cables and place the indoor unit on the installation plate.
1. To avoid condensation problems, place heat-resistant
polyethylene foam separately around each refrigerant
pipe in the lower part of the indoor unit.
2. Wind insulating tape around the pipe, assembly cable
and drain hose.
3. Place the resulting bundle carefully in the lower part
of the indoor unit, making sure that it does not jut out
from the rear of the indoor unit.
4. Hook the indoor unit up to the installation plate and
move the unit to the right and left until you are sure
that it is securely to place in.
5. Finish wrapping insulating tape around the rest of the
piping leading to the outdoor unit.
6. Using clamps (optionally supplied), attach the piping to
the wall wherever possible.
00150A(2)-37~53 2/5/01 11:44 AM Page 52
To Next Page
Loading...
