PAY ATTENTION!
- Never run any program without inserting a reasonably large product containing water into the
baking compartment of the bread maker to avoid damage of plastic parts of the lid that are
“cooled” with steam lose from the product.
- Press the function (step) button to store the last change of setting for each step in the memory.
- Programs remain set even after the bread maker is switched off.
- In case of sudden power failure, the program will run for at least another 15 minutes!
- When the running program is coming to the next function, you will hear a short beep. There is a
long whistle at the end of the program.
- If the temperature in the bread maker is below 5 °C or the internal temperature sensor is
broken: the bread maker whistles and the display shows „LLL“
- In case of bread maker overheating (230-240 °C), the program shuts down heating, the
bread maker whistles and the display shows „HHH“
- If you do not want to use the hook for „pulling“ kneaders out of the finished bread (each
kneader damages up to 4 slices of bread), always use “fast kneading” (i.e. set the motor power to
P3) and then remove the kneaders. In three minutes, you are able to knead the largest amount of
dough, including “heavy” completely rye dough! Do not be afraid of the high speed of the
kneaders, it is only about twice the speed of conventional bread makers.
- Measuring cups are less practical for owners of digital kitchen scales. With daily basic food
preparation, the function “tare” (fast reset) shortens the preparation time. If the scale is able to
measure with an accuracy of 1 g, you can easily weigh salt and spice.
- Sensor buttons are very sensitive and therefore we recommend locking the keyboard after
switching the program on (press and hold the lock button for 2 seconds). This is particularly
advantageous when the bread maker is within the reach of children or when you have increased
moisture in the kitchen. Because of different finger properties of everyone, find the best place on
the button which responds most sensitively to your touch – e.g. on the left, right or inner edge of
the button symbol.
smartbreadmaker.com
- 28 -
SmartBreadMaker
To Next Page
Loading...