EasyManua.ls Logo

Sana SMART BREAD MAKER - Page 32

Sana SMART BREAD MAKER
60 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
- Bread pan removing and inserting:
Grab the edge of the pan with your fingers and pull upward to release e.g. its right side. Simultaneously,
the other side is released too and the pan can be easily removed.
When inserting the bread pan, place it on the carrier in
the middle of the bottom of the baking compartment
and press on the right and left side. If the pan does not fit
in on both sides, remove it again, turn the kneader shaft
and repeat.
Attention: If the pan is hot, leave it cool down or use
oven gloves.
- Teflon and galvanized surfaces of home bread makers are subject to wear. The same is with
bearing and gear belts.
- Some parts of the bread maker and some accessories are made by hand in small
quantities. Therefore, there could be any minor deficiencies in finishing, packaging or design.
However, we believe you will definitely be satisfied with their practicality and long life.
- Baking pan washing: Stainless or Teflon baking pan cannot be washed in dishwasher. In general,
the food stainless steel is very resistant to mechanical and chemical action. However, this does not
apply to the stand with bearings. Some chemical cleaners would corrode it.
Good advice: Based on our experience, we recommend not to clean the stainless inside of the bread
pan thoroughly - do not polish it excessively because the metal material would affect the biochemical
value of our food more intensely. Laboratory analyses have clearly shown that the thinner our food is
and the better contact with metal it has, the more the amount of vitamins decreases. This phenomenon
is most relevant for liquid foods (sauces, milk, drinks, etc.). On the contrary, the biological value of firmer
texture (various cakes, steaks or dough) is in the contact with the metal almost unchanged.
- Removing „bakedkneaders from the bread using a hook. You will use it only for special
recipes or in the case you forget to remove kneaders after
the last kneading. In such cases, turn the loaf upside down,
insert the narrow side of the hook into the hole made by
akneader axis, hook the kneader and pull it out.
smartbreadmaker.com
- 30 -
SmartBreadMaker