Thank you for using the machine from GUANGZHOU TEYU
ELECTROMECHANICAL CO., LTD. Please read the User Manual carefully before use
and keep it properly.
This User Manual is not a quality warranty book. GUANGZHOU TEYU
ELECTROMECHANICAL CO., LTD reserves the rights to the interpretation of any
correction of typographical errors, improper mentioned information and product
improvement. The amended content will be printed in reprint edition of User Manual
without notice in advance.
<1> Cautions
1. Please ensure that the power supply and electrical outlet are in good contact
and the earth wire must be firmly grounded!
Although the average operating current of the chiller is small, but the
instantaneous operating current could be up to 6 ~ 10amps sometimes (The
instantaneous operating current of models of AC110V power supply are
possible to be up to 10 ~ 15amps).
2. Please make sure the chiller’s working voltage is stable and standard.
As the refrigerate compressor is more sensitive to voltage of power supply, the
standard working voltage of our standard machines is 210~240V (110V model is
100~120V).
3. Unmatched frequency of power supplies can leading to chiller damage !
Choose 50Hz or 60Hz model according to actual circumstance.
4. In order to protect the water pump, it is strictly forbidden to run the chiller
without water in water tank
The new machine will empty all water in water tank before packing in the box,
so make sure the water tank is filled with water before starts the machine or the
water pump will damage easily. When water gauge of water tank below green
NORMAL area, the refrigeration volume will drops a little, please make sure the
water gauge is around the green NORMAL area. To drain through circulating
pump is strictly prohibited.
5. Please be sure that the air inlet and air outlet are in good ventilation!
The air outlet that is at the back of the chiller at least 30cm away from
obstructions, and 8cm for the side air inlet.
6. The filter of air inlet requires cleaning regularly.
It is important to wash the anti-dust gauze regularly by removed it from chiller,
because if anti-dust gauze heavy accumulated dust will lead to chiller failure.
7. Please pay attention to condensate water.
When water temperature lower than ambient temperature, and ambient
humidity is higher, the condensate water will generate on the surface of circular
water pipes and surface of devices which being cooled. If it happens, setting
higher water temperature or keep warm for water pipes and devices will be
recommended.
8. The machine is industrial equipment, only professional people allowed to use.
To Next Page
Loading...
