S&C IntelliRupter PulseCloser Instruction Sheet

Qualified Persons
WARNING
The equipment covered by this publication must be installed, operated, and
maintained by qualified persons who are knowledgeable in the installation,
operation, and maintenance of overhead electric power distribution equipment
along with the associated hazards. A qualified person is one who is trained and
competent in:
• The skills and techniques necessary to distinguish exposed live parts from
nonlive parts of electrical equipment
• The skills and techniques necessary to determine the proper approach distances
corresponding to the voltages to which the qualified person will be exposed
• The proper use of the special precautionary techniques, personal protective
equipment, insulating and shielding materials, and insulated tools for working
on or near exposed energized parts of electrical equipment
These instructions are intended only for such qualified persons. They are not
intended to be a substitute for adequate training and experience in safety
procedures for this type of equipment.
Read this
Instruction Sheet
N OTICE
Read this instruction sheet thoroughly and carefully before installing or operating
your IntelliRupter PulseCloser Fault Interrupter. Familiarize yourself with the
Safety Information and Safety Precautions on pages 4 and 5. The latest
version of this publication is available online in PDF format at sandc.com/en/
support/product-literature/.
Retain this
Instruction Sheet
This instruction sheet is a permanent part of your IntelliRupter® fault interrupter.
Designate a location where it can be easily retrieved for reference.
Proper Application
WARNING
The equipment in this publication must be selected for a specific application. The
application must be within the ratings furnished for the selected equipment.
Special Warranty
Provisions
The standard warranty contained in S&C’s standard conditions of sale, as set forth in
Price Sheets 150 and 181, applies to the IntelliRupter fault interrupter, except that the
rst paragraph of the said warranty is replaced by the following:
(1) Gener a l: The seller warrants to the immediate purchaser or end user for a period of
10 years from the date of shipment that the equipment delivered will be of the kind and
quality specified in the contract description and will be free of defects of workmanship
and material. Should any failure to conform to this warranty appear under proper and
normal use within 10 years after the date of shipment, the seller agrees, upon prompt
notification thereof and confirmation that the equipment has been stored, installed,
operated, inspected, and maintained in accordance with the recommendations of the
seller and standard industry practice, to correct the nonconformity either by repairing
any damaged or defective parts of the equipment or (at the seller’s option) by shipment
of necessary replacement parts. The seller’s warranty does not apply to any equipment
that has been disassembled, repaired, or altered by anyone other than the seller. This
limited warranty is granted only to the immediate purchaser or, if the equipment is
purchased by a third party for installation in third-party equipment, the end user of
the equipment. The seller’s duty to perform under any warranty may be delayed, at the
seller’s sole option, until the seller has been paid in full for all goods purchased by the
immediate purchaser. No such delay shall extend the warranty period.
Introduction
2 S&C Instruction Sheet 766-520

S&C IntelliRupter PulseCloser Specifications

General

Brand	S&C
Model	IntelliRupter PulseCloser
Category	Industrial Electrical
Language	English