Overview
These instructions cover the Wi-Fi, SCADA, and GPS
communication setup of an IntelliRupter PulseCloser
Fault Interrupter. The communication module contains
a Wi-Fi transceiver, a GPS receiver, and, if specied, a
radio providing wide-area network capability in SCADA
applications. The communication module may also include
a battery that supports operation for approximately four
hours after loss of ac line voltage on both sides of the
IntelliRupter fault interrupter, permitting extended dead-
line switching.
IntelliRupter fault interrupter software must be
installed on a portable IBM/PC-compatible computer.
Refer to instruction Sheet 766-530, “IntelliRupter®
PulseCloser® Fault Interrupter: Pr ot ecti on an d
Communication Setup,” for the software installation
procedure.
6 S&C Instruction Sheet 766-520
To Next Page
Loading...
