Sanwa PC5000a - Storage

D-1034-143a PC5000（E）
DRAWING No. PC5000a 07-0812 2040 6010
—
32
—

Remove the battery lid screw by a screwdriver.

Removed the battery lid.

Take out the battery or fuse, and replace it with a new one.

Attach the battery lid and fix it by the screwdriver.
Battery lid
Battery (9V)
Battery lid screw
Rear case
Fuse 12.5A/500V
IR: 20kA
ø6.3 x 32mm
Fuse 0.63A/500V
IR: 200kA
ø6.3 x 32mm
Set a battery carefully being sure to observe the correct polarities.
CAUTION
6-4 Storage
1.The panel and the case are not resistant to volatile solvent
and must not be cleaned by thinner or alcohol. For cleaning,
use dry, soft cloth and wipe it lightly.
2.The panel and the case are not resistant to heat. Do not place
the instrument near heat-generating devices (such as a
soldering iron).
3. Do not store the instrument in a place where it may be
subjected to vibration or from where it may fall.
4. For storing the instrument, avoid hot, cold or humid places or
places under direct sunlight or where condensation is
anticipated.
CAUTION
Following the above instructions, store the instrument in good
environment. (See 8-1)