-E17-
Common Operation
Turning the power on and off
Main unit (DVD Receiver)
BEFORE OPERATION
To reduce the volume temporarily (muting)
Press [MUTE] on the remote control. “MUTE” blinks on the
display.
To restore the previous volume setting, press [MUTE] again.
Selecting the sound mode
1. Press [SOUND] repeatedly to select the desired sound mode
(“BASS”, “TREBLE” or “NIGHT”).
2. Press the button as desired.
To turn the power off, press [z/ON] again.
Selecting the source
Press [FUNCTION] to select the desired source. Each time the
button is pressed, the display changes as follows:
DVD/CD v AUX v FM TUNER v DVD/CD...
• When the source selection is changed, disc playback
automatically stops.
Adjusting the volume
Press [VOLUME] + or - on the remote control (or press [VOL] + or
- on the main unit). The volume level appears on the display
(VOL 0 ~ VOL MAX).
Sound mode Press Display change
BASS p or o “-5” ~ “+5”
TREBLE p or o “-5” ~ “+5”
NIGHT ENTER “ON” or “OFF”
Note for “NIGHT” mode:
When enjoying a DVD disc with the volume set low at night,
select this mode. It enhances spoken lines making speech
clearer.
3. Repeat steps 1 to 2 for another sound mode.
4. Press [SOUND] repeatedly to close the display.
Bass boost system
Press [BASS] repeatedly to select the desired bass boost effect.
BOOST v BASS OFF v NORMAL v BOOST. . .
Adjusting the FL display brightness
While holding [n] down on the main unit, press [ON SCREEN]
repeatedly on the remote control.
Press [z/ON] to turn the power on.
• “HELLO” appears briefly on the display.
(After connecting the power cord, when you press [z/ON] for the
first time, the volume-reset feature automatically sets the initial
volume level.)
When the power cord is connected to the AC outlet, the unit will
respond to commands from the remote control.
To turn the power off, press [z/ON] again.
• “GOOD-BYE” appears briefly on the display.
Smart start function
If the following buttons are pressed when the power is turned
off, the unit turns on automatically and the selected source is
activated.
[q], [a] (Front panel of the main unit)
[q], [a], [TUNER] (Remote control)
Rear speaker
Press [z/ON] to turn the power on. The power indicator lights.
To Next Page
Loading...
Need help?
General
