Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish
to operate.
DVD indicator
VCR indicator
SOURCE button
VCR button
DVD button
DVD mode
Press [SOURCE] on the front panel or press [DVD] on
the remote control.
(Verify that the DVD indicator is lit.)
VCR mode
Press [SOURCE] on the front panel or press [VCR] on
the remote control.
(Verify that the VCR indicator is lit.)
Note
•
You cannot switch to another mode while in the timer-standby mode.
•
Playback will stop when you change the output mode.
1) Press [DVD].
2) Press [A] to open the disc tray.
3) Place the disc on the disc tray with its label side
facing up.
Align the disc to
the disc tray guide.
4) Press [A] to close the disc tray.
It may take a while to load the disc.
To eject the disc:
Press [A] to open the disc tray, then remove the disc
before turning the unit to the standby mode.
1) Press [VCR].
2) Insert a cassette tape as illustrated below.
4 HEAD HI-FI STEREO
Cassette compartment
•
Insertfromtheapsiderstwiththewindowside
facing up.
To eject the cassette tape:
Press [C A] on the front panel or press [A] on the
remote control.
How to Insert a Disc How to Insert a Cassette Tape
How to Insert a Disc / Cassette Tape
Switching DVD / VCR Mode
BEFORE YOU START
Note
•
If you turn this unit to the standby mode, [
A
] on the remote control is not available. Be sure to use [
A
] or [
C
A
] on the unit.
To Next Page
Loading...
