THU JAN/29 11:00AMSP (1:00)
JAN/30/15 12:00 AM L1 SP
Date Start End L1/L2
JAN/30 12:00AM 1:00AM L1
New Program
4a) To delete the timer program:
1 Use [K / L] to select the program you want to
delete, then press [OK].
2 Use [K / L] to select “Delete”, then press [OK].
Confirmation window will appear.
3 Use [K / L] to select “Yes”, then press [OK].
4b) To correct the timer program:
1 Use [K / L] to select the program you want to
correct, then press [OK].
2 Use [K / L] to select “Program Change”, then
press [OK].
3 Correct the timer program by using
[K / L / { / B], then press [OK].
5) Press [TIMER] to exit.
6) Press [TIMER SET] to return to the timer standby
mode.
Note
•
Press [TIMER] to check the timer recording in progress.
When the timer recording is proceeding, that
program will be highlighted with red. In this case, you
cannot select any other program.
Timer Programming
1/1
FRI JAN/30 11:00AM
Date Start End L1/L2
E41 JAN/30 12:00AM 1:00AM L1
New Program
Each error number means:
E1-22
E37-39
Recording error other than below
E23-24 Unrecordable disc
E25-28 Copy prohibited program
E29 Disc protected
E30 Disc full
E31-32 Already 99 titles recorded
E33 Already 999 chapters recorded
E34 No space for Control information
E35 PCA full *
1
E36 Already finalized video format disc
E40
Some portion has not been recorded because of program
overlapping. Recording did not start at the start time.
E41 Power failed
E42 No disc when recording
•
A program with the error number is grayed in the timer
programming list.
•
Timer program with an error number will be cleared
once the entry screen for the program is displayed.
*
1
PCA is a disc's space reserved for recording test.
To stop the timer recording in progress
1) Press [C] on the remote control.
2) Confirmation message will appear. Select “Yes”,
then press [OK].
•
To stop the timer recording immediately, press
[ C ] on the unit.
To Next Page
Loading...
