Sanyo PDG-DHT100L - Page 43

-43-
Electrical Adjustment
White 100%
Black 100%
Black and noisy
image appears
[3] Manual adjustment (Component)
Input mode Video mode (Input 2 -Component)
Input signal 100% color bar signal (480i)
1. Select Group "260", No. "100" and set data value to "4".
2. Adjust the data values listed in the table below as the
100% white part on the screen becomes the most
noisy (darkest).
Group No. Adjustment
10 - 3 Y Gain
3. Select Group "260", No. "100" and set data value to "5".
4. Adjust the data values listed in the table below as the
100% white part on the screen becomes the most
noisy (darkest).
Group No. Adjustment
0 - 3 Y Gain
5. Select Group "260", No. "100" and set data value to "0".
[2] Manual adjustment (Slot)
Input mode Computer mode (Input 3)
Input signal 16-step gray scale computer signal
Slot board Analog RGB input board equipped
1. Select Group "260", No. "100" and set data value to "2".
2. Adjust the data values listed in the table below as the
100% white part on the screen becomes the most
noisy (darkest).
Group No. Adjustment
10 - 3 ADC-Green Gain
10 - 4 ADC-Red Gain
10 - 5 ADC-Blue Gain
3. Select Group "260", No. "100" and set data value to "0".
When the PC, Video or Component Auto Calibration
fails, take the following manual adjustment instead of
auto calibration.
[1] Manual adjustment (PC)
Input mode Computer mode
Input signal 16-step gray scale computer signal
1. Select Group "260", No. "100" and set data value to "1".
2. Adjust the data values listed in the table below as the
100% white part on the screen becomes the most
noisy (darkest).
Group No. Adjustment
10 - 3 ADC-Green Gain
10 - 4 ADC-Red Gain
10 - 5 ADC-Blue Gain
3. Select Group "260", No. "100" and set data value to "3".
4. Adjust the data values listed in the table below as the
100% white part on the screen becomes the most
noisy (darkest).
Group No. Adjustment
0 - 3 ADC-Green Gain
0 - 4 ADC-Red Gain
0 - 5 ADC-Blue Gain
5. Select Group "260", No. "100" and set data value to "0".
W Y C G M R B BK
Black and noisy
image appears
[4] Manual adjustment (Video)
Input mode Video mode (Input 2 -Composite)
Input signal 16-step gray scale composite video
signal
1. Select Group "260", No. "100" and set data value to "6".
2. Adjust the data values listed in the table below as the
100% white part on the screen becomes the most
noisy (darkest).
3. Select Group "260", No. "100" and set data value to "0".
Group No. Adjustment
20 - 0 Y Level
PC, Video, Component Manual adjustment
Image example of manual adjustment
for [PC / Slot / Video]
Image example of manual adjustment
for [Component]