Sanyo PLC-WTC500AL - Part Names and Functions: Side Terminals; USB and Control Port Connectors

12
!1R/C JACK
When using the wired remote control, connect the
wired remote control to this jack with a remote
control cable (not supplied).
Side Terminal
!3CONTROL PORT CONNECTOR
When controlling the projector with RS-232C,
connect the control equipment to this connector
with the serial control cable.
Part Names and Functions
!0USB CONNECTOR (Series B)
Use this connector when controlling a computer
with the remote control of the projector. Connect
the USB terminal of your computer to this
connector with the supplied USB cable (p.20).
!2VIDEO INPUT JACK
Connect the composite video output signal from
video equipment to this jack (p.21).
!0 !1 !2 !3